LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Engine "ON".
  2. Install Scan tool and monitor the "MASS AIR FLOW" parameter on the Scan tool data list.

    Specification: Approx. 10 ~ 20kg/h at idle & No load

  3. Is MAF sensor voltage near the specified value?

    YES: 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO: 

    • Check MAFS for contamination, deterioration, or damage. Substitute with a known-good MAFS and check for proper operation. If the problem is corrected, replace MAFS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.