LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check voltage
    1. IG "OFF" and disconnect CKPS connector.
    2. IG "ON" & ENG "OFF"
    3. Measure voltage between terminal 1 of CKPS harness connector and chassis ground.
    4. Measure voltage between terminal 2 of CKPS harness connector and chassis ground.

      Specification: Approx. 1.4V

    5. Is the measured voltage within specification?

      YES 

      NO 

      • Go to  2 "Check open in harness" as follows.
  2. Check open in harness
    1. IG "OFF" and disconnect CKPS connector and PCM connector.
    2. Measure resistance between terminal 1 of CKPS harness connector and terminal 41 of PCM harness connector.
    3. Measure resistance between terminal 2 of CKPS harness connector and terminal 21 of PCM harness connector.

      Specification: Below 1Ω

    4. Is the measured resistance within specification?

      YES 

      NO