LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check short to ground in harness
    1. IG "OFF" and disconnect TPS connector and PCM connector.
    2. Measure resistance between terminal 6 of TPS harness connector and chassis ground.
    3. Measure resistance between terminals 6 and 5 (8) of TPS harness connector.

      Specification: Infinite

    4. Is the measured resistance within specification?

      YES 

      • Go to  2 "Check open in harness" as follows

      NO 

  2. Check open in harness
    1. IG "OFF" and disconnect TPS connector and PCM connector.
    2. Measure resistance between terminal 6 of TPS harness connector and terminal 57 of PCM harness connector.

      Specification: Below 1Ω

    3. Is the measured resistance within specification?

      YES 

      NO