LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check short to ground in harness.
    1. IG "OFF"
    2. Disconnect MAPS and PCM connector.
    3. Measure the resistance between terminal 1 of MAPS harness connector and ground.

      Specification: Infinite

    4. Is the measured resistance within the specification?

      YES 

      • Go to  2 "Check open in the harness" procedure.

      NO 

  2. Check open in the harness
    1. IG "OFF"
    2. Disconnect MAPS and PCM connector.
    3. Measure the resistance between terminal 1 of MAPS harness connector and terminal 8 of PCM harness connector

      Specification: Approx. below 1 Ω

    4. Is the measured resistance within the specification?

      YES 

      NO