LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Visual Inspection of HO2S.
    1. Visually/physically inspect following items:
      1. Inspect the front HO2S for Contaminated, deteriorated or aged Front HO2S.
      2. If contamination is evident on the HO2S, replace contaminated sensor.
    2. Is the HO2S visually/physically OK?

      YES

      • Go to " 2 Check Performance of HO2S" as below.

      NO

      • Substitute with a known - good HO2S and check for proper operation.

        If the problem is corrected, replace HO2S and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check performance of HO2S.
    1. Warm-up the engine to normal engine temperature.
    2. Connect scantool and Engine "ON".
    3. Monitor HO2S voltage (B1/S1) parameter on scantool.

      Specification: Verify that the signal is switching from rich (above 0.45V) to lean (below 0.45V) a minimum of 3 time seconds (voltage will vary between 0.1 and 0.9V).

      Fig 1: Monitoring HO2S Voltage (B1/S1) Parameter On Scantool
      G07375080
    4. Is the sensor switching properly?

      YES

      • Go to " 3 Check PCM" as below.

      NO

      • Substitute with a known - good HO2S and check for proper operation.

        If the problem is corrected, replace HO2S and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  3. Check PCM.
    1. Ignition "OFF" & Engine "OFF".
    2. Connect Scantool and Ignition "ON".
    3. Select simulation function on scantool.
    4. Simulate voltage at terminal 1 of HO2 sensor signal connector.
      Fig 2: Screen Display - HO2S Voltage Simulation
      G07375081
    5. Does the HO2 sensor signal value changes according to simulation voltage?

      YES

      • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector. Thoroughly check connector looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO

      • Substitute with a known - good PCM and check for proper operation.

        If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.