LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Check ECTS.
    1. Ignition "OFF".
    2. Disconnect ECT sensor connector.
    3. Measure resistance between terminals "1" and "3" of the ECT sensor connector.

      Specification: (error range is 2~3%.)

      TEMPERATURE AND RESISTANCE REFERENCE CHART

      Temperature (°C/°F) -30 (-22° F) -20 (-4°F 0 (32°F) 20 (68°F) 40 (104° F) 60 (140° F) 80 (176° F) 100 (212° F) 110 (230° F)
      Resistance (kΩ) 26.74 15.48 5.79 2.45 1.148 0.587 0.322 0.188 0.147
      Voltage (V) 4.39 4.17 3.48 2.56 1.68 1.04 0.63 0.39 0.31
    4. Is the measured resistance within specifications?

      YES

      • Go to " 2 Check PCM" as below.

      NO

      • Check ECT sensor for contamination, deterioration, or damage. Substitute with a known-good ECT sensor and check for proper operation. If the problem is corrected, replace ECT sensor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  2. Check PCM.
    1. Ignition "OFF".
    2. Connect scantool and Ignition "ON".
    3. Select simulation function on scantool.
    4. Simulate voltage at terminal "3" of ECT sensor signal connector.
      Fig 1: Screen Display - ECT Sensor Voltage Simulation
      G07375024
    5. Does the signal value of ECT sensor change according to simulation voltage?

      YES

      • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO

      • Substitute with a known - good PCM and check for proper operation.

        If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.