LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Check performance test.
    1. Ignition "OFF".
    2. Connect MAP connector.
    3. Remove the MAP sensor and turn the ignition key to the ON position.
    4. Using s hand-held vacuum pump, apply vacuum and measure the "MAP SENSOR" parameter on scantool.

      Specification:

      PRESSURE AND VOLTAGE REFERENCE CHART

      Applied Vacuum Output Voltage
      10 kPa (100 mbar, 1.45 psi) 0.06V
      5 kPa (150 mbar, 2.18 psi) 0.25V
      40 kPa (400 mbar, 5.8 psi) 1.3V
      80 kPa (800 mbar, 11.6 psi) 3V
      120 kPa (1200 mbar, 17.4 psi) 4.8V
    5. Is the parameter displayed within specification?

      YES

      • Go to " 2 Check PCM" as below.

      NO

      • Substitute with a known - good MAP and check for proper operation.

        If the problem is corrected, replace MAP and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check PCM.
    1. Ignition "OFF" & Engine "OFF".
    2. Connect scantool and Ignition "ON".
    3. Select simulation function on scantool.
    4. Simulate voltage at terminal 1 of MAP sensor signal connector.
      Fig 1: Screen Display - MAP Sensor Voltage Simulation
      G07374965
    5. Does the signal value of MAP sensor changes according to simulation voltage?

      YES

      • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO

      • Substitute with a known - good PCM and check for proper operation.

        If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.