Component Inspection
- Check performance test.
- Ignition "OFF".
- Connect MAP connector.
- Remove the MAP sensor and turn the ignition key to the ON position.
- Using s hand-held vacuum pump, apply vacuum and measure the "MAP SENSOR" parameter on scantool.
Specification:
PRESSURE AND VOLTAGE REFERENCE CHARTApplied Vacuum Output Voltage 10 kPa (100 mbar, 1.45 psi) 0.06V 5 kPa (150 mbar, 2.18 psi) 0.25V 40 kPa (400 mbar, 5.8 psi) 1.3V 80 kPa (800 mbar, 11.6 psi) 3V 120 kPa (1200 mbar, 17.4 psi) 4.8V - Is the parameter displayed within specification?
YES
- Go to " 2 Check PCM" as below.
NO
- Substitute with a known - good MAP and check for proper operation.
If the problem is corrected, replace MAP and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Check PCM.
- Ignition "OFF" & Engine "OFF".
- Connect scantool and Ignition "ON".
- Disconnect MAP sensor connector and Select simulation function on scantool.
- Simulate voltage at terminal 1 of MAP sensor signal connector.
- Does the signal value of MAP sensor changes according to simulation voltage?
YES
- Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good PCM and check for proper operation.
If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.