Cruise Control Communication Circuit Troubleshooting (A/T)
- Start the engine.
- Turn on the cruise control main switch, then drive the vehicle to speeds over 25 mph (40km/h) with the cruise control.
Does the cruise control operate ?
YES - Go to step 3.
NO - Check the cruise control unit or cruise control actuator.
- Measure the voltage between the O/D control terminal of the cruise control unit connector and ground.
Is there approx. 1V?
YES - Go to step 4.
NO - Replace the cruise control unit.
- Measure the voltage between the cruise control terminal of the TCM (or PCM) connector and ground.Fig 2: Measuring Voltage Between Cruise Control Terminal No 8 To Of TCM (Or PCM) Connector And Ground
Courtesy of HYUNDAI MOTOR CO.
Fig 3: Measuring Voltage Between Cruise Control Terminal No 12 To Of TCM (Or PCM) Connector And GroundCourtesy of HYUNDAI MOTOR CO.
Is there approx. 1V?
YES - Check for loose connectors. If necessary, replace the TCM and recheck. (See AUTOMATIC TRANSAXLE SYSTEM )
NO - Repair short or open in the wire between the TCM (or PCM) terminal and cruise control unit.