LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check for short to heater control in harness
    1. Ignition "OFF"
    2. Disconnect HO2S sensor connector and PCM connector.
    3. Ignition "ON" & Engine "OFF"
    4. Measure resistance between terminal 2, 3 of sensor harness connector.

      Specification: infinite

      Fig 1: Measuring Resistance Between Terminal 2, 3 Of Sensor Harness Connector
      G03851811Courtesy of HYUNDAI MOTOR CO.
    5. Is measure resistance within Specification?

      YES 

      NO 

      • Short circuit between HO2S signal circuit and heater control circuit.
      • Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.