LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check for short to ground in harness
    1. Ignition "OFF"
    2. Disconnect Fuel sender connector and PCM connector.
    3. Ignition "ON" & Engine "OFF"
    4. Measure resistance between terminal 1 and 3 of Fuel sender harness connector.
    5. Measure resistance between terminal 1 and 3 of Fuel sender harness connector and chassis ground.

      Specification: infinite

      Fig 1: Measuring Resistance Between Terminal 1 And 3 Of Fuel Sender Harness Connector And Chassis Ground
      G03851969Courtesy of HYUNDAI MOTOR CO.
    6. Is measure resistance within Specification?

      YES 

      NO 

      • Short circuit to ground between Fuel sender harness connector and sender signal circuit.
      • Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.