LEMON Manuals: Even more car manuals for everyone

Component Inspection

The purpose of measuring INJ resistance is to find if the open circuit is in the component.

  1. Check INJ
    1. Measure resistance between terminal 1 and 2 of sensor connector (To sensor side)

      Specification: 20°C (68°): 13.8~15.20

      Fig 1: Measuring Resistance Between Terminal 1 And 2 Of Sensor Connector
      G03851849Courtesy of HYUNDAI MOTOR CO.
    2. Is measure resistance within Specification?

      YES 

      • Substitute with a known-good PCM and check for proper operation. If the problem is corrected, replace PCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Substitute with a known-good INJ and check for proper operation. If the problem is corrected, replace INJ and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
        NOTE: The purpose of measuring injector resistance is to find if the open circuit is in the component. Check the continuity between signal line and ground line.