LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check for open in harness (signal)
    1. Check for open in harness (signal)
    2. Disconnect HO2S sensor connector.
    3. Ignition "ON" & Engine "OFF"
    4. Measure voltage between terminal 2 of sensor harness connector and chassis ground.

      Specification: approximately 0.45V

      Fig 1: Measuring Voltage Between Terminal 2 Of Sensor Harness Connector And Chassis Ground
      G03851821Courtesy of HYUNDAI MOTOR CO.
    5. Is measure voltage within Specification?

      YES 

      • Go to "Check for open in harness (ground)" below.

      NO 

      • Open circuit between HO2S harness connector and PCM harness connector.
      • Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  2. Check for open in harness (ground)
    1. Ignition "OFF"
    2. Disconnect HO2S sensor connector and PCM connector.
    3. Ignition "ON" & Engine "OFF"
    4. Measure resistance between terminal 1 of sensor harness connector and PCM harness connector.

      Specification: below 1Ω

      Fig 2: Measuring Resistance Between Terminal 1 Of Sensor Harness Connector And PCM Harness Connector
      G03851822Courtesy of HYUNDAI MOTOR CO.
    5. Is measure resistance within Specification?

      YES 

      NO 

      • Open circuit between HO2S harness connector and PCM harness connector.
      • Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.