Removal & Installation
- Front HO2S is mounted in exhaust pipe in front of catalytic converter. Rear HO2S (if equipped) is located after the catalytic converter. HO2S has a permanent pigtail which must be protected from damage when removing sensor. DO NOT use any cleaning solvents. Ensure exhaust system is cool before removing HO2S, or thread damage may occur.
- Disconnect negative battery cable and HO2S connector. Remove HO2S. To install, reverse removal procedure. Ensure sensor is free of contaminants. If reinstalling old sensor, apply anti-seize compound to HO2S threads. Tighten to specification. See TORQUE SPECIFICATIONS. Install negative battery cable.