Code 3153 - Throttle Position (TP) Sensor Malfunction
- Turn ignition off. Unplug connector from throttle position sensor. Turn ignition on. Test for battery voltage between harness connector terminal No. 2 (White/Black wire) and ground. If voltage is 4.8-5.2 volts, go to next step. If voltage is not as specified, repair White/Black wire between sensor and terminal No. 12 of ECM connector.
- Test Black wire at harness connector for continuity to ground. If continuity does not exist, repair Black or Black/Yellow wire between sensor connector and ECM connector terminal No. 30. See appropriate WIRING DIAGRAM in WIRING DIAGRAMS
section.
- Turn ignition off. Unplug ECM connector. Test for continuity between sensor harness connector terminal No. 1 (Green/Red wire) and ECM connector terminal No. 53. Test same wire for short to ground or to another wire. If wire is okay, go to next step. Repair circuit as necessary.
- Turn ignition off. Unplug TP sensor harness connector. Measure resistance between sensor terminals No. 2 and 3. See Fig 1
. Resistance should be 1200-2800 ohms. Measure resistance between sensor terminals No. 1 and 3. Operate throttle from closed to full position. Monitor ohmmeter while opening throttle. Resistance should change smoothly according to throttle movement. Replace TP sensor if operation is not as specified.
Courtesy of HYUNDAI MOTOR CO.
- If scan tester is not available, go to next step. Connect and operate scan tester according to manufacturer's instructions. Read TP service data item No. 23. Scan tester should display throttle angle. See TP SENSOR SPECIFICATION table. If display is as specified, go to next step. If display is not as specified, temporarily substitute known good TP sensor, then retest system.
TP SENSOR SPECIFICATION
| Engine RPM |
Throttle Angle Non-Turbo |
Throttle Angle Turbo |
| 800 |
8-12° |
8-12° |
| 2000 |
9-15° |
10-18° |
| 3000 |
12-20° |
12-20° |
| WOT |
94-98° |
94-98° |
- Temporarily substitute known good TP sensor, then retest system. If sensor is okay, temporarily substitute known good ECM, then retest system.