LEMON Manuals: Even more car manuals for everyone

Code 3153 - Throttle Position (TP) Sensor Malfunction

  1. Turn ignition off. Unplug connector from throttle position sensor. Turn ignition on. Test for battery voltage between harness connector terminal No. 3 (Black/Yellow wire) and ground. If voltage is 4.8-5.2 volts, go to next step. If voltage is not as specified, repair Black/Yellow wire between sensor and terminal No. 12 of ECM connector.
  2. Unplug ECM connector. Test White/Black wire at harness connector for continuity to ECM harness connector terminal No. 30. If continuity does not exist, repair White/Black ECM connector. See appropriate wiring diagram in WIRING DIAGRAMS  section.
  3. Turn ignition off. Test for continuity between sensor harness connector terminal No. 1 (Green/Black wire) and ECM connector terminal No. 53. Test same wire for short to ground or to another wire. If wire is okay, go to next step. Repair circuit as necessary.
  4. Turn ignition off. Unplug TP sensor harness connector. Measure resistance between sensor terminals No. 2 (White/Black wire on mating connector) and No. 3 (Black/Yellow wire on mating connector. Resistance should be 700-3000 ohms. Measure resistance between sensor terminals No. 1 and 3. Operate throttle from closed to full position. Monitor ohmmeter while opening throttle. Resistance should change smoothly according to throttle movement. Replace TP sensor if operation is not as specified.
  5. If scan tester is not available, go to next step. Connect and operate scan tester according to manufacturer's instructions. Read TP Sensor service data item No. 23. Scan tester should display throttle angle. See TP SENSOR SPECIFICATION table. If display is as specified, go to next step. If display is not as specified, temporarily substitute known good TP sensor, then retest system.
    TP SENSOR SPECIFICATION

    Engine RPM Throttle Angle
    800 5-15°
    2000 9-15°
    3000 12-20°
    WOT 94-98°
  6. Temporarily substitute known good TP sensor, then retest system. If sensor is okay, temporarily substitute known good ECM, then retest system.