LEMON Manuals: Even more car manuals for everyone

Diagnostic Aids

The following conditions may cause this DTC to set:

DTC P0017

Step Action Yes No
Schematic Reference:  Engine Controls Schematics 
Connector End View Reference:  Powertrain Control Module (PCM) Connector End Views  or  Engine Controls Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Observe the Freeze Frame/Failure Records for this DTC.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?
Go to Step 3  Go to Diagnostic Aids
3
  1. Turn OFF the ignition.
  2. Inspect the crankshaft balancer bolt for the proper torque. Refer to Fastener Tightening Specifications and Crankshaft Balancer Replacement in Engine Mechanical.
Was the crankshaft balancer bolt at the proper torque?
Go to Step 4  Go to Crankshaft Balancer Replacement in Engine Mechanical
4
  1. Disconnect the camshaft position (CMP) actuator solenoid.
  2. Remove the CMP actuator solenoid. Refer to Camshaft Position (CMP) Actuator Solenoid Valve Replacement .
  3. Connect a jumper wire between the high control circuit of the CMP actuator solenoid and 12 volts. Refer to Using Connector Test Adapters in Wiring Systems.
  4. Connect a jumper wire between the low reference circuit of the CMP actuator solenoid and a good ground. Refer to Using Connector Test Adapters in Wiring Systems.
Does the pintle inside the CMP actuator solenoid move?
Go to Step 5  Go to Step 7 
5 Inspect the CMP actuator for binding or being stuck. Refer to Camshaft Position (CMP) Actuator Diagnosis in Engine Mechanical.
Did you find and correct the condition?
Go to Step 8  Go to Step 6 
6 Inspect the engine for correct valve timing. Refer to Timing Chain and Sprockets Replacement in Engine Mechanical.
Did you find and correct the condition?
Go to Step 8  Go to Diagnostic Aids
7 Replace the CMP actuator solenoid valve. Refer to Camshaft Position (CMP) Actuator Solenoid Valve Replacement .
Did you complete the replacement?
Go to Step 8  -
8
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?
Go to Step 2  Go to Step 9 
9 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?
Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information System OK