LEMON Manuals: Even more car manuals for everyone

Side Engine Mount Removal and Installation: Removal

  1. Remove the PCM (see PCM REPLACEMENT ).
  2. Remove the front receiver line (A) from the clip (B), and the A/C suction line mounting bracket bolt (C).
    Fig 1: Identifying Front Receiver Line, Clip And A/C Suction Line Mounting Bracket Bolt
    G08078592Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the engine wire harness connector (D), the harness clamps (E), and the PCM bracket (F).
  4. Lift and support the engine with a jack and a wood block under the oil pan.
  5. Remove the ground cable bracket (A), then remove the upper half of the side engine mount bracket (B).
    Fig 2: Identifying Ground Cable Bracket And Upper Half Of Side Engine Mount Bracket
    G08078593Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the wire harness bracket (A) and the side engine mount (B).
    Fig 3: Identifying Wire Harness Bracket And Side Engine Mount
    G08078594Courtesy of AMERICAN HONDA MOTOR CO., INC.