LEMON Manuals: Even more car manuals for everyone

Recirculation Control Motor Circuit Troubleshooting (Without Climate Control)




Recirculation Control Motor Circuit Troubleshooting

1. Check the No. 30 (10 A) fuse in the driver's under-dash fuse/relay box.

Is the fuse OK?

YES -

Go to step 2.

NO -

Replace the fuse, and recheck.�

2. Disconnect the recirculation control motor 7P connector.

3. Turn the ignition switch to ON (II).

4. Measure the voltage between recirculation control motor 7P connector terminal No. 1 and body ground.





Is there battery voltage?

YES -

Go to step 5.

NO -

Repair an open in the wire between the No. 30 (10 A) fuse in the driver's under-dash fuse/relay box and the recirculation control motor.�

5. Turn the ignition switch to LOCK (0).

6. Test the recirculation control motor Recirculation Control Motor Test.

Is the recirculation control motor OK?

YES -

Go to step 7.

NO -

Replace the recirculation control motor Recirculation Control Motor Replacement, or repair the recirculation control linkage or doors.�

7. Disconnect A/C control panel connector A (22P).

8. Check for continuity between body ground and A/C control panel connector A (22P) terminals No. 5 and No. 6 individually.





Is there continuity?

YES -

Repair a short to body ground in the wire(s) between the A/C control panel and the recirculation control motor.�

NO -

Go to step 9.

9. Turn the ignition switch to ON (II), and measure the same terminals for voltage to body ground.





Is there any voltage?

YES -

Repair a short to power in the wire(s) between the A/C control panel and the recirculation control motor. This short may also damage the A/C control panel. Repair a short to power before replacing the A/C control panel.�

NO -

Go to step 10.

10. Turn the ignition switch to LOCK (0).

11. Check for continuity between the following terminals of A/C control panel connector A (22P) and the recirculation control motor 7P connector.









Is there continuity?

YES -

Check for loose wires or poor connections at A/C control panel connector A (22P) and at the recirculation control motor 7P connector. If the connections are good, substitute a known-good A/C control panel, and recheck. If the symptom/indication goes away, replace the original A/C control panel A/C Control Panel Removal/Installation.�

NO -

Repair an open in the wire(s) between the A/C control panel and the recirculation control motor.�