LEMON Manuals: Even more car manuals for everyone

DTC 54: Fail-safe Relay

  1. Clear the DTC using the HDS (see HOW TO RETRIEVE DTCS  ).
  2. Disconnect the HDS from the 16P DLC.
  3. Turn the ignition switch OFF, then turn it ON (II) again.
  4. Test-drive the vehicle around a number of corners.
  5. Turn the ignition switch ON (II).
  6. Measure the voltage between the VSA control unit 47P connector terminal No. 47 and body ground.
    Fig 1: Measuring Voltage Between VSA Control Unit 47P Connector Terminal No. 47 And Body Ground
    G04547514Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there 0.1 V or less? 

    YES  - Go to step 7.

    NO  - Repair open or high resistance in the wire between the VSA modulator-control unit and body ground (G302).

  7. Clear the DTC using the HDS (see HOW TO RETRIEVE DTCS  ).
  8. Turn the ignition switch OFF, then turn it ON (II) again.
  9. Test-drive the vehicle.

    Does the ABS indicator come on, and is DTC 54 indicated? 

    YES  - Check for loose connector terminals and repair if necessary. Replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION  ).

    NO  - The system is OK at this time.