LEMON Manuals: Even more car manuals for everyone

Check Trans And Cruise Set Indicators Are Flashing (01-044)

Publication date: 2001-05-08
Reference number: 01-044

CHECK TRANS AND CRUISE SET INDICATORS ARE FLASHING

CHECK TRANS AND CRUISE SET INDICATORS ARE FLASHING

TECHNICAL SERVICE BULLETIN

Reference Number(s): 01-044, Date of Issue:  May 8, 2001
HONDA: 2000-01 Passport
CATEGORY: Electrical
APPLIES TO: 2000 Passport - All; 2001 Passport - From VIN 4S6...58W.14400001 thru 4S6..58W.14409430

SYMPTOM

The CHECK TRANS and CRUISE SET indicators on the instrument panel flash when the ignition switch is turned to ON (II).

PROBABLE CAUSE

Using a brand of spark plugs other than Denso can cause the PCM to detect an additional crank sensor pulse. If this happens, the PCM resets itself and turns on the CHECK TRANS and CRUISE SET indicators.

CORRECTIVE ACTION

Update the PCM software with the Smart Cable.

TOOL INFORMATION

PGM Tester loaded with SN131 (04/16/01) or later software.

For other tools and equipment needed to update the PCM software, refer to Service Bulletin 99-005, Updating the Passport PCM, filed under Tools.

WARRANTY CLAIM INFORMATION

In warranty:   The normal warranty applies.

Operation Number: 122305

Flat Rate Time: 0.3 hour

Failed Part: P/N 8-09392-189-0

H/C 6392971

Defect Code: 093

Contention Code: C05

Template ID: 01-044A

Skill Level: Repair Technician

Out of warranty:   Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.

REPAIR PROCEDURE

  1. Retrieve the PCM broadcast code with the PGM Tester. (From the MISC TESTS menu, select BROADCAST CODE.)
  2. Compare the retrieved code with these codes:
    • DCLY
    • DCLX
    • DCYA
    • DCYB
    • DDNP
    • DDNN
    • DHYX
    • DHYZ
    • DJTC
    • DJTF

    If the code you retrieved is not in the list, the PCM has already been updated. Troubleshoot other causes for the PCM to reset.

    If the code you retrieved is in the list, go to step 3.

  3. If not already done, load the May 2001 or later HONDANET 2000 CD on your HONDANET 2000 master terminal. Loading instructions are included in the CD's mailing.
  4. Update the PCM software with the Smart Cable and the broadcast code information on the HONDANET 2000 CD. For updating instructions, refer to Service Bulletin 99-005, Updating the Passport PCM, filed under Tools.
    NOTE: Since the Smart Cable may need to be cleared from previous PCM update or the Smart Cable firmware may need to be reprogrammed, always begin each vehicle's PCM software updating at the HONDANET 2000 workstation. Make sure you select the most recent broadcast code from the list on the HONDANET screen. (This code is not necessarily at the top of the list. The most recent code is the last on e in alphabetical sequence, letter by letter.) For example, among the codes DJTF, DDNN, and DCLY, the most recent code is DJTF.
  5. Use the PGM Tester to clear any DTCs.
  6. After you update the PCM, retrieve the PCM broadcast code with the PGM Tester. Make sure the code does not match and from the list in step 2.