LEMON Manuals: Even more car manuals for everyone

Dimmer Switch Circuit

  1. Turn ignition off. Carefully pry dimmer switch from dashboard. Dash light brightness controller is built into dimmer switch assembly. Disconnect dimmer switch 3-pin connector. Inspect connector and switch terminals for damage or corrosion. Repair or replace as necessary.
  2. Use DVOM to check for continuity between dimmer switch 3-pin connector Black wire and ground. If continuity exists, go to next step. If continuity does not exist, repair open Black wire or poor ground connection (G401). See WIRING DIAGRAMS  .
  3. With headlight switch on, use DVOM to check for battery voltage between dimmer switch 3-pin connector Red/Black wire and ground. If battery voltage is indicated, go to next step. If not, replace underdash fuse No. 30 (7.5 amp).
  4. With headlight switch on, use a jumper wire to ground dimmer switch 3-pin connector Red wire. If dash lights illuminate, dimmer switch circuits are okay, replace dimmer switch. If dash lights do not illuminate, repair open in Red wire.