Power Steering Pump: Disassembly
- Remove pump from vehicle. See STEERING PUMP under REMOVAL & INSTALLATION. Mount pump in soft-jawed vise. Hold pulley using spanner wrench. Remove pulley nut. See Figure . Pulley nut has left-hand threads. Remove control valve cap. Remove spring, control valve and "O" rings.
- Remove inlet joint and "O" ring. Remove pump cover and "O" ring. Remove pump cam ring from housing. Remove pump rotor and vanes. Remove 2 rollers from side plate. Remove side plate and preload spring.
- Remove "O" rings from side plate. Remove circlip and driveshaft from pump housing. Remove seal spacer and seal. Using a press, remove bearing from driveshaft.
NOTE:
Replace power steering pump as an assembly if damage or excessive wear exist on control valve, pump housing, side plate, rotor, vanes or pump cam ring.