LEMON Manuals: Even more car manuals for everyone

Accumulator & Modulator Bleeding

CAUTION: Do not loosen the relief plug on the accumulator.
  1. Remove service cap from maintenance bleeder on modulator unit. Attach wrench to maintenance bleeder. Place one end of a rubber tube over maintenance bleeder. Place other end of tube in a suitable container to collect fluid. See Figure .
  2. While holding tube, slowly open bleeder 1/8 to 1/4 turn to release pressure.
    CAUTION: Do not loosen the maintenance bleeder too much. The high-pressure brake fluid can burst out.
  3. Tighten the maintenance bleeder. Do not remove the rubber tube and wrench yet.
  4. Have an assistant start and let engine idle for a minute. Allow fluid to flow from tube until no air bubbles are present. Turn engine off.
  5. Check the brake fluid level in the reservoir. It should be below the MAX (upper) level line.
  6. Repeat steps  2 - 5 to drain the rest of the brake fluid from the modulator unit.
  7. Remove the cap, and refill the reservoir to the MAX (upper) level with fresh brake fluid. Pour the brake fluid slowly so that it does not foam, and wait for a few minutes.
  8. Repeat steps  2 - 5 twice, and refill the reservoir to the MAX (upper) level with fresh brake fluid.
  9. Tighten the maintenance bleeder to the specified torque. See TORQUE SPECIFICATIONS  . After replacement, start and idle engine. Depress brake pedal. If brake system will not hold pressure, the hydraulic system still contains air. Repeat previous steps.
  10. Make sure that the ABS indicator light goes off. If the ABS indicator light comes on and the pump motor stops, restart the engine and repeat steps  2 - 4 . If ABS control unit has a stored Diagnostic Trouble Code (DTC), clear DTC from control unit memory. See CLEARING  DTCs under SELF-DIAGNOSTICS.