Power Door Lock Control Unit
NOTE:
Several different wires have the same color. They have been given a number suffix to distinguish them (for example, GRN/RED1
and GRN/RED2
are not the same).
Remove the passenger's door panel, then disconnect the 18-P connector from the control unit. See DOOR TRIM PANEL under REMOVAL & INSTALLATION. Inspect the connector terminals to be sure they are all making good contact. See Fig 1 .
- If any terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, make the following input tests at the connector terminals. See Fig 2 and Fig 3 .
- If a test indicates a problem, find and correct the cause, then recheck the system.
- If all input test prove okay, the control unit must be faulty; replace it.