LEMON Manuals: Even more car manuals for everyone

Installation Procedure

  1. GM3766595Courtesy of GENERAL MOTORS COMPANY

    Install the rear side door outside handle bracket cable retainer (1) to the new bracket (2).

  2. Install the lock cylinder blank to the new bracket.
  3. Install the rear side door outside handle cable. Refer to Rear Side Door Outside Handle Cable Replacement .
  4. GM3766825Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure that the counter balance is reset and locked in the detent of the handle bracket. The counter balance can Not be reset after the latch and handle bracket has been reinstalled in the door.

    Set the rear side door outside handle bracket counter balance (1) as follows:

    1. The outside door handle can Not be install until the counter balance (1) is reset.
    2. Grasp the rear side door outside handle bracket (2) with one hand.
    3. From the back side of the counter balance (1), push forward until the counter balance locks into the detent of the handle bracket.
  5. GM3766542Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Bracket should be slid full rearward prior to tightening bracket fastener.

    Install the outside handle bracket (1) and the rear side door latch (2) assembly in the vehicle as one. Refer to Rear Side Door Latch Replacement .

  6. GM3766594Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Install the rear side door outside handle bracket fastener (1) to the door (2) and tighten to 3.5 N.m (31 lb in).

  7. Install the rear side door outside handle. Refer to Rear Side Door Outside Handle Replacement .
  8. Ensure that the door lock system operates properly before installing the door trim.