LEMON Manuals: Even more car manuals for everyone

Circuit/System Testing

    NOTE:

    It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: G10 Cooling Fan Motor
  3. Ignition - On / Vehicle - In Service Mode
  4. Verify a test lamp turns On between the test points: Ground circuit terminal 2 & B+
    • If the test lamp does not turn On and the circuit fuse is OK 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Test for less than 2 ohms between the test points: B+ circuit terminal 1 & Output terminal @ Fuse
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Repair the open/high resistance in the ground connection.
    • Go to next step: If the test lamp turns On 
  5. Test or replace the component: G10 Cooling Fan Motor