LEMON Manuals: Even more car manuals for everyone

Circuit/System Verification

  1. Ignition OFF
  2. Test for 12.0 V at the battery terminals.
    • Go to next step: If 12.0 V 
  3. Verify that there are no A/C lines, heater houses or other accessory equipment misrouted or rubbing against the generator causing the noise to be transmitted into the passenger compartment.
    • If there is a line rubbing condition 

      Reroute or realign the hose or line.

    • Go to next step: If there is no line rubbing condition 
  4. Remove the engine drive belt. Verify all the belt driven devices spin freely and do not produce any unusual sounds.
    • If they do not spin freely or they make an unusual sound 

      Replace the affected component.

    • Go to next step: If they spin freely and no unusual sound is given 
  5. Inspect the generator, its alignment, and its bolt torque.
    • Go to next step: If the generator is aligned and torqued properly 
  6. Ignition ON
  7. Engine running idle, verify that the noise concern is not engine related.
    • If the noise concern is engine related 

      Proceed to engine mechanical diagnostic information and procedures for the appropriate engine.

    • Go to next step: If the noise concern is not engine related 
  8. Ignition OFF
  9. Install the engine drive belt.
  10. Ignition ON, engine running idle.
  11. Verify the generator is not producing unusual noise.
    • Go to next step: If the generator is not producing unusual noise 
  12. All OK.