LEMON Manuals: Even more car manuals for everyone

Installation Procedure

Important:  Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

  1. . Install the EBCM (2) onto BPMV (1).

    Important:  Do not reuse the old mounting bolts. Always install new bolts with the new BPMV.

  2. Install the four EBCM bolts. Tighten the four bolts to 5 N.m (39 lb in) in an X-pattern.
  3. Connect the 2 way ABS pump motor connector to the EBCM.
  4. Install the BPMV (1) to BPMV bracket (3).
  5. Install the BPMV to bracket retaining bolts (4). Tighten the bolts to 9 N.m (7 lb ft).
  6. Install the EHCU (1, 2) to the vehicle frame (5). Tighten the three EHCU bracket bolts (4) to 25 N.m (18 lb ft).
  7. Connect the two electrical harness connectors to the EBCM (1).

    Important:  The brake pipes are held in the proper place by a frame mounted plastic bracket. Make sure that the brake pipes stay in the correct place for proper reassembly.

  8. Install the 5 brake pipes to the BPMV (6). Tighten the brake pipe fittings to 25 N.m (18 lb ft).
  9. Connect negative battery cable.
  10. Bleed the brake system. Refer to ABS Automated Bleed Procedure .