LEMON Manuals: Even more car manuals for everyone

Instrument Panel Upper Section: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Remove the instrument panel. Refer to: Instrument Panel 
  2. Remove the drive knee airbag. Refer to: Driver Knee Airbag
    1. Remove the bolts.

      Torque: 22 lb.in (2.5 Nm)

    2. Release the clips disconnect the electrical connector and remove the lower steering column trim panel.
    GFD773587Courtesy of FORD MOTOR COMPANY
  3. Move the steering wheel to the lowest position.
    GFD773588Courtesy of FORD MOTOR COMPANY
  4. Release the upper steering column shroud tabs.
    GFD773589Courtesy of FORD MOTOR COMPANY
  5. Center the steering wheel.
    GFD773590Courtesy of FORD MOTOR COMPANY
  6. Remove the upper steering column shroud and lower IPC trim panel.
    GFD773591Courtesy of FORD MOTOR COMPANY
  7. Remove the bolts and the lower steering column shroud.
    GFD773592Courtesy of FORD MOTOR COMPANY
  8. Disconnect the electrical connectors.
    GFD773593Courtesy of FORD MOTOR COMPANY
  9. Remove the APIM Refer to: SYNC Module [APIM]
  10. Remove the screws and the climate control assembly.

    • Disconnect the electrical connectors.

    GFD773594Courtesy of FORD MOTOR COMPANY
  11. Remove the bolt, release the harness retainers and position aside the harness.

    Torque: 71 lb.in (8 Nm)

    GFD773595Courtesy of FORD MOTOR COMPANY
  12. Remove the upper trim panel.
    GFD772805Courtesy of FORD MOTOR COMPANY
  13. Remove the screws and the IPC.

    • Disconnect the electrical connector.

      Torque: 22 lb.in (2.5 Nm)

    GFD773596Courtesy of FORD MOTOR COMPANY
  14. On both sides. Refer to: A-Pillar Trim Panel
    1. Remove the passenger side air bag to in-vehicle cross beam bolts.

      Torque: 80 lb.in (9 Nm)

    2. Disconnect the electrical connectors release the harness retainers and position aside harness.
    GFD773597Courtesy of FORD MOTOR COMPANY
  15. Remove the bolts and the steering column.

    Torque: 18 lb.ft (25 Nm)

    GFD773598Courtesy of FORD MOTOR COMPANY
  16. Disconnect the electrical connectors and position the harness aside.
    GFD773599Courtesy of FORD MOTOR COMPANY
  17. Remove the hose.
    GFD773600Courtesy of FORD MOTOR COMPANY
  18. Remove the bolts.

    Torque: 80 lb.in (9 Nm)

    GFD773601Courtesy of FORD MOTOR COMPANY
  19. Remove the bolts.

    Torque: 80 lb.in (9 Nm)

    GFD773602Courtesy of FORD MOTOR COMPANY
  20. NOTE: Make sure that all electrical connectors and wiring are not hindered before removing the instrument panel upper section or damage to the components may occur.

    Remove the instrument panel upper section.

    • Disconnect the electrical connector, release the harness retainers and position aside the harness.

GFD773603Courtesy of FORD MOTOR COMPANY