LEMON Manuals: Even more car manuals for everyone

Tie Rod End: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. NOTE: Disconnect the battery ground cable anytime the steering linkage is being serviced or damage to the steering gear may occur resulting in steering gear replacement.

    Refer to: Battery Disconnect and Connect - Vehicles With: Single Battery . Refer to: Battery Disconnect and Connect - Vehicles With: Dual Batteries .

  2. Remove the wheel and tire. Refer to: Wheel and Tire .
    1. Loosen the tie rod end jam nut.

      Torque: 59 lb.ft (80 Nm)

    2. NOTE: Use the hex-holding feature to prevent the stud from turning while removing/installing the nut.

      Remove and discard the outer tie rod end nut.

      Torque: 85 lb.ft (115 Nm)

    3. NOTE: Do not use a hammer to separate the tie-rod end from the wheel knuckle or damage to the wheel knuckle may result.
      NOTE: Use care when installing the tie rod separator or damage to the tie-rod end boot may occur.

      Separate the tie rod end from the wheel spindle. Use the General Equipment: Tie Rod End Remover

    GFD636795Courtesy of FORD MOTOR COMPANY
  3. NOTE: Count and record the number of turns required to remove the outer tie-rod end for reference during installation.

    Remove the tie rod end.

GFD636796Courtesy of FORD MOTOR COMPANY