LEMON Manuals: Even more car manuals for everyone

Steering Gear: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. If installing a new steering gear, connect the scan tool and upload the module configuration information from the PSCM. Refer to: Module Configuration - System Operation and Component Description .
  2. Remove the front subframe. Refer to: Front Subframe .
  3. Disconnect the steering gear electrical connectors.
    GFD636784Courtesy of FORD MOTOR COMPANY
  4. NOTE: This step is only necessary when installing a new component.

    Remove the retainers and the steering gear heat shield.

    Torque: 62 lb.in (7 Nm)

    GFD636785Courtesy of FORD MOTOR COMPANY
  5. NOTE: If equipped. 
    NOTE: This step is only necessary when installing a new component.

    Remove the retainers and the steering gear heat shield.

    Torque: 62 lb.in (7 Nm)

    GFD636786Courtesy of FORD MOTOR COMPANY
  6. Remove and discard the steering gear mounting retainers and remove the steering gear.

    Torque: 129 lb.ft (175 Nm)

GFD636787Courtesy of FORD MOTOR COMPANY