LEMON Manuals: Even more car manuals for everyone

Hydraulic Control Unit (HCU): Removal

NOTE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
NOTE: The HCU and ABS module are serviced as an assembly.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    If installing a new HCU/ ABS module, upload the Anti-Lock Brake System (ABS) module configuration to the scan tool. Refer to: Module Configuration - System Operation and Component Description .

  1. 2.

    Remove the battery tray. Refer to: Battery Tray .

  1. 3.

    Disconnect the ABS module electrical connector.
GFD48342Courtesy of FORD MOTOR COMPANY

  1. 4.

    Disconnect the brake tube fittings.

    Torque: 159 lb.in (18 Nm)

GFD48343Courtesy of FORD MOTOR COMPANY

  1. 5.

    Disconnect the brake tube fittings and remove the brake tubes.

    Torque: 18 lb.ft (25 Nm)

GFD48344Courtesy of FORD MOTOR COMPANY

  1. 6.

    Remove the bolt, detach the 2 bracket isolators and remove the HCU and bracket.
GFD48345Courtesy of FORD MOTOR COMPANY

  1. 7.

    Remove the 3 bolts and the HCU bracket.

    Torque: 80 lb.in (9 Nm)

GFD48346Courtesy of FORD MOTOR COMPANY