LEMON Manuals: Even more car manuals for everyone

Ignition Coil-On-Plug: Removal

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: HEALTH AND SAFETY PRECAUTIONS .

    Refer to: ENGINE IGNITION - COMPONENT LOCATION .

  2. If equipped, remove the engine cover.
  3. NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plug and surrounding area before removing the ignition coil-on-plug.

    Disconnect the 4 ignition coil-on-plug electrical connectors.

  4. Remove the 4 ignition coil-on-plug bolts.

    Torque  : 89 lb.in (10 Nm)

  5. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
    NOTE: When installing apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation.

    Remove the 4 ignition coil-on-plugs.

    Material  : Silicone Brake Caliper Grease and Dielectric Compound/XG-3-A (ESE-M1C171-A)