LEMON Manuals: Even more car manuals for everyone

Tie Rod - Inner: Installation

    NOTE: Thoroughly remove any abrasive material. This material is extremely harmful to the steering gear.
  1. Thoroughly clean the bellows boot-to-steering gear housing mating surface and install the O-ring supplied with the new bellows boot.
  2. NOTE: Use an appropriate-sized wrench on the flat of the rack gear to resist rotation and to prevent damage during the installation of the inner tie rod.
    Fig 1: Installing Inner Tie Rod Using Set Screw Style Inner Tie Rod Tool
    G06256313Courtesy of FORD MOTOR CO.
  3. While holding the steering gear rack, use a set screw style inner tie rod tool (such as Matco® stock # TRT48) to install the inner tie rod.
    • Tighten to 83 Nm (61 lb-ft).
  4. Apply the specified grease to the bellows boot-to-steering gear mating surfaces and bellows boot grooves in the inner tie-rod casting.
  5. NOTE: Make sure the bellows boot is positioned correctly over the steering gear housing bead and the groove in the inner tie rod.
  6. Install the steering gear bellows boot.
  7. Using bellows boot clamp pliers, install a new inner bellows boot clamp.
  8. Install the tie-rod jam nut onto the inner tie rod.
  9. NOTE: Install the outer tie rod end(s) the same number of turns recorded during removal.
  10. Install the outer tie-rod end.
  11. Connect the outer tie-rod end to the wheel knuckle and install the outer tie-rod end nut.
    • Tighten to 53 Nm (39 lb-ft).
  12. Tighten the tie-rod jam nut to 63 Nm (46 lb-ft).
  13. Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  14. Check and if necessary, adjust the front toe. For additional information, refer to SUSPENSION SYSTEM - GENERAL INFORMATION .