LEMON Manuals: Even more car manuals for everyone

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Installation of a new receiver/drier is not required when repairing the air conditioning system, except when there is physical evidence of contamination from a failed A/C compressor or damage to the receiver/drier.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Recover the refrigerant. For additional information, refer to CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS article.
  3. Remove the RH lower engine splash shield.
  4. Fig 1: Identifying Splash Shield
    GF0042563Courtesy of FORD MOTOR CO.
  5. Remove the front bumper cover. For additional information, refer to BUMPERS article.
  6. Remove the condenser inlet fitting nut and disconnect the fitting.
    • Discard the O-ring and gasket seals.
    • To install, tighten to 15 Nm (11 lb-ft).
  7. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
    • Discard the O-ring and gasket seals.
    • To install, tighten to 15 Nm (11 lb-ft).
  8. Remove the compressor-to-condenser discharge line.
  9. To install, reverse the removal procedure.
  10. Evacuate, leak test and charge the refrigerant system. For additional information, refer to CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS article.