LEMON Manuals: Even more car manuals for everyone

Removal and Installation

  1. Remove the tie-rod end and jam nut. For additional information, refer to TIE ROD END .
  2. Remove the boot.
    1. Remove and discard the clamps.
    2. Disconnect the breather pipe (if equipped).
    3. Remove the boot.
    Fig 1: Removing Boot
    G03950227Courtesy of FORD MOTOR CO.
  3. CAUTION: Make sure the tie-rod is clean before installing the boot.
    NOTE: Install new boot clamps.
    NOTE: To prevent the steering gear boot from twisting during toe adjustment, apply long-life grease to the groove in the tie-rod and uniformly to the inner diameter of the steering gear boot.
  4. To install, reverse the removal procedure.
  5. Using the special tool, tighten the steering gear boot clamp.
Fig 2: Using Special Tool To Tighten Steering Gear Boot Clamp
G04000730Courtesy of FORD MOTOR CO.