Transmission Fluid Drain and Refill: Installation
- Install the transaxle drain plug.
- After the fluid has been drained, clean the drain plug threads and apply a small amount of Pipe Sealant with Teflon® D8AZ-19554-A or XW7Z-19554-AA or equivalent meeting Ford specification WSK-M2G350-A2.
Courtesy of FORD MOTOR CO.
- Lower the vehicle
- Add 3.7 liters (3.9 quarts) of MERCON® Multi-Purpose (ATF) Transmission Fluid XT-2-QDX or equivalent meeting Mercon® specification.
- Start the engine and run through all gears for a total of five minutes at idle. Turn off the engine.
- Repeat the previous steps to help flush fluid from the torque converter.