LEMON Manuals: Even more car manuals for everyone

Removal and Installation

  1. Remove the instrument panel cluster opening finish panel assembly.
    Fig 1: Removing Instrument Panel Cluster Opening Finish Panel Assembly
    G02765930Courtesy of FORD MOTOR CO.
  2. Remove the ignition switch lock cylinder (11582).
    1. Position the lock cylinder to RUN.
    2. Using a suitable tool, push upward on the cylinder release tab through the hole in the lower shroud while pulling the cylinder outward.
    Fig 2: Removing Ignition Switch Lock Cylinder
    G02765931Courtesy of FORD MOTOR CO.
  3. Remove the upper steering column shroud.
    Fig 3: Removing Upper Steering Column Shroud
    G02765932Courtesy of FORD MOTOR CO.
  4. Remove the transmission range selector lever. Disconnect the electrical connector.
    Fig 4: Removing Transmission Range Selector Lever
    G02765933Courtesy of FORD MOTOR CO.
  5. NOTE: Install a new transmission range selector lever pin whenever it is removed.
  6. To install, reverse the removal procedure.