LEMON Manuals: Even more car manuals for everyone

Removal & Installation

CAUTION: Do not pull on the ignition wire directly, as the wire may separate from the connector inside the spark plug boot.

Disconnect the accelerator cable retaining clip. Grasp the spark plug boot firmly and with a twisting pulling motion, disconnect the spark plug wires from the spark plugs. See Fig 1. Squeeze the locking tabs and twist while pulling upward to disconnect the spark plug wires from the ignition coil and remove the wires. Whenever an ignition wire is reinstalled, or a new one is installed, apply dielectric compound to the interior surface of the spark plug wire boot. To install, connect the spark plug wires to the correct ignition coil terminal. Connect the spark plug wires to the correct spark plugs. Connect the accelerator cable retaining clip.

Fig 1: Removing Spark Plug Wires
G00234415Courtesy of FORD MOTOR CO.