LEMON Manuals: Even more car manuals for everyone

Selector Lever Cable And Bracket - Column Shift: Removal

  1. Remove the LH lower instrument panel trim.
    Fig 1: Removing Lower Instrument Panel Trim
    G01576485Courtesy of FORD MOTOR CO.
  2. Reach up from the left side of the column, then using a small screwdriver, pry the shift cable from the shift selector lever pivot ball.
    Fig 2: Removing Shift Cable
    G01576486Courtesy of FORD MOTOR CO.
  3. Remove the shift cable from the retaining bracket by carefully lifting up on the locking tab while pulling up on the shift actuator cable fitting.
  4. From the engine compartment, remove the cruise control actuator. For additional information, refer to VEHICLE SPEED CONTROL .
  5. Pry the cable grommet from the dash panel.
    Fig 3: Removing Cable Grommet
    G01576487Courtesy of FORD MOTOR CO.
  6. Remove the nut holding the shift cable to the manual control lever.
    Fig 4: Removing Nut Holding Shift Cable
    G01576488Courtesy of FORD MOTOR CO.
  7. Lifting up on the locking tab while pulling up on the shift cable, remove the shift cable from the transmission shift cable bracket.
    • Discard the locking clip.
      Fig 5: Removing Shift Cable
      G01576489Courtesy of FORD MOTOR CO.
  8. Pull the shift cable through the dash panel opening.