LEMON Manuals: Even more car manuals for everyone

DTC B1410: Left Front Power Window Motor Circuit Failure

NOTE: If any other DTC is retrieved with DTC B1410, service that DTC first.
  1. Check GEM PID D_PWAMP  - Using NGS tester, access GEM PID D_PWAMP. Press driver door master window switch left front window to UP position. Check PID. If GEM PID D_PWAMP indicates no current, go to next step. If GEM PID D_PWAMP indicates current, go to step 5).
  2. Check Resistance To Motor  - Ensure ignition is off. Disconnect GEM 26-pin connector C233 and 22-pin connector C234 (located behind instrument panel, on left side of steering column). Using an ohmmeter, check resistance between GEM 26-pin connector C233 terminal No. 2 (Tan/Black wire) and GEM 22-pin connector C234 terminal No. 1 (White/Black wire). See Figure . If resistance is more than 5 ohms, go to next step. If resistance is 5 ohms or less, replace GEM and repeat GEM self-test.
  3. Check Tan/Black Wire  - Access and disconnect driver door power window motor connector C512. Using an ohmmeter, check resistance in Tan/Black wire between GEM 26-pin connector C233 terminal No. 2 and driver door power window motor connector C512 Tan/Black wire terminal. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Tan/Black wire and repeat GEM self-test.
  4. Check For Shorted Power Window Motor  - Using an ohmmeter, check resistance between GEM 26-pin connector C233 terminal No. 1 (Tan/Red wire) and driver door power window motor connector C512 Tan/Black wire terminal. If resistance is less than 5 ohms, replace driver door power window motor and repeat GEM self-test. If resistance is 5 ohms or more, repair open in Tan/Red wire and repeat GEM self-test.
  5. Check Tan/Black Wire For Short To Ground  - Ensure ignition is off. Disconnect GEM 26-pin connector C233 (located behind instrument panel, on left side of steering column). Using an ohmmeter, check resistance between ground and GEM 26-pin connector C233 terminal No. 2 (Tan/Black wire). See Figure . If resistance is 10 k/ohms or more, go to next step. If resistance is less than 10 k/ohms, repair short to ground in Tan/Black wire and repeat GEM self-test.
  6. Check Tan/Red Wire  - Access and disconnect driver door power window motor connector C512. Using an ohmmeter, check resistance between ground and GEM 26-pin connector C233 terminal No. 1 (Tan/Red wire). If resistance is 10 k/ohms or more, replace driver door master window switch and repeat GEM self-test. If resistance is less than 10 k/ohms, repair short to ground in Tan/Red wire and repeat GEM self-test.