LEMON Manuals: Even more car manuals for everyone

Circuit Test B - EEC-V Power Relay

This circuit test is only intended to diagnose the following components and circuits:

Fig 1: EEC-V Power Relay Test Circuits
G96C29126

  1. Check VPWR Circuit Resistance

    Turn ignition off. Disconnect Idle Air Control (IAC) solenoid and EEC-V power relay wiring harness connectors. Disconnect scan tool (if applicable). Measure resistance between VPWR terminal of IAC solenoid connector and VPWR terminal of EEC-V power relay. If resistance is less than 5 ohms, reconnect IAC solenoid and go to next step. If resistance is 5 ohms more, repair open in VPWR circuit between EEC-V power relay and IAC solenoid.
  2. Check Voltage To EEC-V Power Relay

    Leave ignition off and EEC-V power relay disconnected. Connect DVOM negative lead to negative battery terminal. Measure voltage at B+ terminal of EEC-V power relay connector. Turn ignition on. Measure voltage at IGN START/RUN. If voltage is less than 10.5 volts, repair open circuit and repeat QUICK TEST . If voltage is more than 10.5 volts, replace EEC-V power relay and repeat QUICK TEST .
  3. Check Ground Circuit To EEC-V Power Relay

    Leave ignition off and EEC-V power relay disconnected. Measure voltage between Ground terminal and B+ terminal of EEC-V power relay. If resistance is more than 10.5 volts, replace EEC-V power relay. If resistance is 10.5 volts or less, repair open in Ground circuit and repeat QUICK TEST .