Diagnostic Aids
Perform this test only when instructed by QUICK TEST or if directed by other test procedures. This code indicates that OBD-II monitor testing has not been completed. To erase code, a complete drive cycle, with successful OBD II monitor self-test must occur.
A drive cycle consists of vehicle warmed to normal engine temperature and operating in all speed ranges. See DRIVE CYCLES under QUICK TEST. After all monitors test successfully, SYSTEM PASS can be retrieved from PCM.
DTC P1000 will set in PCM memory when any of the following conditions occur:
- Battery or PCM has been disconnected.
- An OBD-II monitor has failed before completion of drive cycle.
- PCM memory has been erased with a scan tool.
- 1) Check For Other DTCs If any DTCs are present, service as necessary. If no DTCs are present, go to next step.
- 2) Clear DTC P1000 To clear DTC P1000, perform OBD-II drive cycle. See DRIVE CYCLES under QUICK TEST. If DTC P1000 is still present after completing drive cycle, go to next step.
- 3) Check VSS PID Connect NGS scan tool and access VSS PID. Perform a short road test while monitoring VSS PID. If VSS PID closely matches actual road speed, go to next step. If VSS PID does not match actual road speed, go to CIRCUIT TEST DP.
- 4) Check ECT PID
Drive vehicle long enough to obtain maximum engine temperature. Access ECT PID. If ECT PID is greater than 180°F (82°C), perform drive OBD-II drive cycle. If ECT PID is less than 180°F (82°C), replace engine thermostat. Repeat QUICK TEST.NOTE: A break in step numbering sequence occurs at this point. Procedure skips from step 4) to step 10). No test procedures have been omitted.
- 10) Failure To Complete Mode 1 Perform QUICK TEST. If any DTCs are retrieved, perform repairs as necessary. If No DTCs are retrieved, go to next step.
- 11) Check Air Intake System Check air intake system for air leaks, excessive dirt or other damage. Repair as necessary. If air intake system is okay, go to next step.
- 12) Check PCV System Check PCV system for air leaks, excessive dirt or other damage. Repair as necessary. If PCV system is okay, go to next step.
- 13) Check Sensor Inputs To PCM
Turn ignition off. Connect NGS scan tool. Start engine (drive if necessary) while monitoring the following PIDs:
- ECT (engine coolant temperature).
- IAT (intake air temperature).
- MAF (mass airflow sensor or MC-VAF sensor).
- O2S- (all oxygen sensor PIDs).
- PURGE (evaporative purge solenoid).
Compare values to PID VALUE tables. If PID values are within the expected range, go to next step. If PID values are not within expected range, go to CIRCUIT TEST Z or TESTS W/O CODES article for intermittent diagnostic procedure. Repeat Drive Cycle Mode 1.
- 14) Check EGR Boost Sensor Check EGR boost sensor. See CIRCUIT TEST HE. Repair EGR boost sensor as necessary. Repeat Drive Cycle Mode 1. If EGR boost sensor is okay, go to next step.
- 15) Check Fuel System
Check fuel system for the following concerns:
- Fuel pressure regulator problem.
- Fuel injector malfunction.
- Fuel pump malfunction.
- Fuel pressure.
If any of the above require servicing, perform repair as necessary. Repeat Drive Cycle Mode 1. If the above items are okay, replace PCM. Repeat Drive Cycle Mode 1.