LEMON Manuals: Even more car manuals for everyone

ABS Warning Light Does Not Light

  1. Remove and inspect ABS warning light in dash. If ABS warning light is okay, leave ABS warning light out, go to next step. If ABS warning light is blown, replace bulb. Go to CHECKING ABS WARNING LIGHT SEQUENCE  .
  2. Connect a test light between ABS warning light socket positive terminal and ground. If test light comes on, go to next step. If test light does not light, repair open or short in ABS warning light feed circuit. Reinstall bulb. Go to CHECKING ABS WARNING LIGHT SEQUENCE  .
  3. Open power distribution box. Remove ABS diode. Verify diode terminals are clean and firmly in place. Using a DVOM, check for continuity between ABS warning light socket ground terminal and diode terminal (Dark Green wire). If continuity exists, go to next step. If continuity does not exist, repair open in Dark Green wire. Reinstall ABS diode. Go to CHECKING ABS WARNING LIGHT SEQUENCE  .
  4. Remove ABS system relay. Verify relay terminals are clean and firmly in place. Remove ABS diode. Check for continuity between ABS diode connector Orange/Yellow wire and ABS system relay connector Orange/Yellow wire. If continuity exists, go to next step. If continuity does not exist, repair open in Orange/Yellow wire. Reinstall ABS diode. Go to CHECKING ABS WARNING LIGHT SEQUENCE  .
  5. Check system ground eyelet located at left radiator support for looseness and corrosion. Repair as necessary. Remove ABS system relay. Check for continuity between ABS system relay connector Black wire and ground eyelet located at left radiator support. If continuity does not exist, repair open in Black wire between ABS system relay connector and ground eyelet located at left radiator support. Reinstall ABS system relay. Go to CHECKING ABS WARNING LIGHT SEQUENCE  . If continuity exists, reinstall ABS system relay. Replace ABS warning light. While looking for an intermittent failure, repeat steps 2) thru 5).