LEMON Manuals: Even more car manuals for everyone

Lock Cylinder (Functional): Removal

  1. On all models, disconnect battery ground cable.
  2. On vehicles with tilt wheel, remove column end shroud by unsnapping shroud from retaining clip at 9-o'clock position of shroud. See Figure .
  3. On vehicles with non-tilt wheel, remove upper and lower shrouds. See Figure .
  4. On all models, disconnect key warning switch electrical connector.
  5. Turn lock cylinder to RUN position. Locate small hole in casting below lock cylinder. Insert a 1/8" drill bit or punch into hole. Press lock cylinder retaining pin while pulling lock cylinder out of housing.