Diagnostic Aids
DO NOT enter this test sequence until a Code 11 or 111 (pass code) has been received in KOEO SELF-TEST. If system has not passed KOEO SELF-TEST, code recorded in KOER SELF-TEST may not be valid.
Deactivate self-test by removing and reconnecting jumper wire, or by procedure specified by test equipment in use. Start and run engine for 2 minutes at 2000 RPM to warm-up Heated Exhaust Gas Oxygen (HEGO) sensor. Turn engine off and wait 10 seconds. Activate KOER SELF-TEST using a jumper wire or appropriate procedure for test equipment used. Start engine. Record all service codes displayed. Check the following items:
- If engine starts and stalls, or stalls during self-test, go to TEST S, step 1).
- If vehicle is equipped with a Brake On/Off (BOO) switch, brake pedal MUST be depressed and released AFTER the ID code portion of test.
- On vehicles with Power Steering Pressure Switch (PSPS), turn steering wheel at least 1/2 turn and release within 1-2 seconds after the ID code portion of test.
- On vehicles with E4OD transmissions, the Overdrive Cancel Switch (OCS) MUST be cycled after the ID code portion of the test.
- When the Dynamic Response Code appears, perform a brief Wide Open Throttle (WOT). DO NOT perform WOT unless requested.
- If Code 98 or 998 is displayed, it indicates EEC-IV system is operating in Failure Management Effects Mode (FMEM) and vehicle has not passed KOEO SELF-TEST. Vehicle cannot be diagnosed while in FMEM mode. See Code 98 or 998 in appropriate CONTINUOUS MEMORY CODE chart under CODE-TO-TEST MENU(S).
- If a Code 11 or 111 (pass code) is received during KOER SELF-TEST, service Continuous Memory Codes received in KOEO SELF-TEST. See appropriate CONTINUOUS MEMORY CODE chart under CODE-TO-TEST MENU(S) in this article.
- If a Code 11 or 111 (pass code) is received during the Continuous Memory Code portion of KOEO SELF-TEST (Code 11-1-11) or (11-1-111), and no driveability problem exists, EEC-IV testing is complete. If driveability problems are still present, go to TESTS W/O CODES article in this section.
- If KOER codes are present, refer to appropriate KOER SELF-TEST CODES chart under CODE-TO-TEST MENU(S). If system will not output codes, go to TEST QA, step 1).