LEMON Manuals: Even more car manuals for everyone

2.2L Code 16/False Mil - EGR Valve Position Sensor (89-4-8)

Publication date: 1989-02-22
Reference number: 89-4-8

2.2L CODE 16/FALSE MIL - EGR VALVE POSITION SENSOR

2.2L CODE 16/FALSE MIL - EGR VALVE POSITION SENSOR

TECHNICAL SERVICE BULLETIN

Reference Number(s): 89-4-8, Date of Issue:  February 22, 1989

CONDITIONS

ELECTRONIC ENGINE CONTROL (EEC) - 2.2L - SELF TEST CODE "16" -CALIFORNIA EMISSION VEHICLES ONLY

LIGHT - CHECK ENGINE (MIL) - 2.2L - SELF TEST CODE "16" - CALIFORNIA EMISSION VEHICLES ONLY

APPLICATION

Model(s): FORD: 1989 PROBE

Group: Electrical

Bulletin No.: 89-4-8

Date: February 22, 1989

Symptom: Intermittent Signal

ISSUE

A "check engine" light (MIL) that intermittently flashes "ON" and "OFF" may be caused by a false signal from the EGR valve position sensor to the processor (ECA). The ECA interprets the signal as an EGR valve that is out of position. Service code "16" will be displayed during EEC Self Test.

ACTION

Install a new service wire harness with a resistor between the EGR valve position sensor and its connector. Refer to the following procedure for service details.

  1. Fasten the new wire harness and resistor assembly to the pressure regulator control solenoid bracket, Figure 1.
  2. Disconnect the EGR valve position sensor wire harness connector (connector C140).
  3. Connect one end of the new service wire harness, (E92Z-12A690-A) to the EGR valve position sensor. Connect the other end of the new service wire harness to the C140 connector.
  4. Secure the new service wire harness to the existing wire harness in the area with three (3) tie-straps.
PARTS INFORMATION

PART NUMBER PART NAME CLASS
E92Z-12A690-A Wire Harness & Resistor Assembly W
Fig 1: Installing New Wiring Harness
G91J27408