Heater Core Leak Test Procedure (89-14-9)
Publication date: 1970-01-01Reference number: 89-14-9
HEATER CORE LEAK TEST PROCEDURE
TECHNICAL SERVICE BULLETIN
APPLICATION
1988-89 Ford Crown Victoria, Escort, Festiva, Mustang, Probe, Taurus, Tempo, Thunderbird; 1988-89 Lincoln Continental, Mark VII, Town Car; Mercury Cougar, Grand Marquis, Sable, Topaz, Tracer; 1988-89 Aerostar, Bronco, Bronco II, Econoline, F-150, F-250, F-350, Ranger Light Truck
SUBJECT
Heater Core Leak Test Procedure.
REFERENCE
Ford Technical Service Bulletin No. 89-14-9
CONDITION & CAUSE
Heater cores may be replaced unnecessarily by incorrect diagnosis. An inadequate seal between the heater core tubes may allow coolant to follow the tube to the heater core and appear as a leak.
REPAIR
Use the following inspection and core leak testing procedure if a heater core leak is suspected.
Inspection -
- At the hose to the heater core attachments, look for evidence of coolant leakage. A coolant leak at the hose could follow the heater core tube to the core and this could appear as a leak in the heater core.
- Check the system for loose heater hose clamps. Tighten them to 16-22 Lb. INCH (1.8-2.5 N.m).
- If the hose clamps are tight and leakage is found, check the heater core tubes for distortion or evidence of being bent out of shape. Leakage at the hose connection could be caused by severe distortion of the tubes by such things as over-torqued clamps.
Pressure Test - Heater Core in Vehicle -
- Drain the coolant from the cooling system.
- From the heater core tubes, disconnect the heater hoses.
- On each heater core tube, install a short piece of heater hose approximately 4 INCHES or 10cm long.
- Prepare the heater core as in the following: A. Fill the hoses and heater core with water. B. Install adapter BT-7422-A from Rotunda model 021-0012 or equivalent and plug BT-7422-B in the hose ends. See Fig 1
.
C. Secure the plug, hoses and adapter with hose clamps.
- As described below, air pressure test the heater core.
A. Attach the gauge assembly Rotunda model 021-0012 or equivalent and the pump to the adapter. See Fig 2 .
B. At the base of the gauge, close the bleed valve.
C. Into the heater core, pump 30 PSI of air pressure. See Fig 3 .
- For three minutes observe the pressure gauge. The pressure should not drop.
- No leaks are indicated if the pressure does not drop.
- Check the hose connections to core tubes for leaks if the pressure drops. Remove the heater core from the vehicle and perform the bench air pressure test if the hoses do not leak.
Pressure Test - Heater Core on Bench, Out Of Vehicle -
- Drain all coolant or water from the heater core.
- Connect the 4 INCH test hoses with the adapter and the plug to the core tubes.
- Connect the gauge assembly and air pump to the adapter. See Fig 4 .
- Apply 30 psi of air pressure to the heater core with Rotunda model 021-0012 or equivalent.
- Submerge the heater core in water.
- Repair or replace the heater core, if required, if a leak is observed.