LEMON Manuals: Even more car manuals for everyone

2.2L Eng Intermittent CKECK Engine Light (90-14-7)

Publication date: 1990-07-01
Reference number: 90-14-7

2.2L ENG INTERMITTENT CKECK ENGINE LIGHT

2.2L ENG INTERMITTENT CKECK ENGINE LIGHT

TECHNICAL SERVICE BULLETIN

Reference Number(s): 90-14-7, Date of Issue:  July, 1990

APPLICATION

1989-90 Probe 2.2 Turbo & Non-Turbo California Vehicles

SUBJECT

Code 16 in Memory

REFERENCE

Ford Motor Co., Technical Service Bulletin, No. 90-14-7, July, 1990

CONDITION & CAUSE

An intermittent CHECK ENGINE light may be displayed along with a stored Code 16. This condition may occur because an incorrect vacuum signal is applied to the EGR valve during normal driving and on closed throttle deceleration. The electrical signal sent from the EVP to the ECA is then measured and results in activating the CHECK ENGINE light. According to the manufacturer, this condition does not effect driveability or emission levels

DIAGNOSIS & REPAIR

  1. On 1989 vehicles, ensure the EVP sensor wire harness is correct and properly installed. Using normal service procedures, perform the engine Quick Test. If Code 16 is displayed, perform the appropriate pinpoint tests. If all pinpoint tests result in a pass, go to next step.
  2. If no service codes are displayed during the Key On/Engine Off Self-Test, check EGR valve, EVP sensor, wiring harness and vacuum control solenoids using normal service procedures. If these components pass all tests, go to next step.
  3. Ensure vacuum hose routing is correct as shown on under hood label. Ensure rubber and metal hoses between throttle body, EGR solenoids and EGR valve are in good condition. It is possible that during previous engine repair, the vacuum line(s) could become pinched or kinked and not allow the EGR vent solenoid to quickly dump vacuum on closed throttle deceleration. Vacuum holding the EGR pintle up causes the ECA to trigger the CHECK ENGINE light and set Code 16 in memory.